The DAC is an advanced CMOS/Si-Cr 8-bit multiplying. DAC designed to interface directly with the , ,. , Z80®, and other popular. DAC DAC – 8-bit Microprocessor Compatible, Double-buffered D/A Converter, Package: Mdip, Pin Nb= The is an advanced CMOS/Si-Cr 8-bit. DAC Technical Data, DAC 8-bit D/A Convertor Datasheet, buy DACLCN.
|Published (Last):||5 July 2007|
|PDF File Size:||2.55 Mb|
|ePub File Size:||2.97 Mb|
|Price:||Free* [*Free Regsitration Required]|
We can use the circuit to develop applications without worry as the circuit is tested working. All these control pins need to be setup appropriately as mentioned above for successful DAC conversion of the device.
So the device is used for converting 8 bit parallel digital data input to analog signal output. This op-amp circuit is called current-to-voltage converter. This analog signal is dad0830 current quantity that is directly proportional to the input digital value and this current parameter needed to be converted in to voltage parameter for further use.
The device is specifically designed for it to be interfaced directly with the,Z80, and other popular microprocessors. DAC takes in parallel 8 bit data from a microcontroller or microprocessor and converts that data in to analog signal at the output.
Pin Configuration Vac0830 is a twenty pin device and description for each pin is given below. The design also includes special circuitry that provides TTL logic input voltage level compatibility. For working of device DAC we have connected a voltage source of 15V as shown in diagram. Double buffering of the device allows outputting a voltage corresponding to one digital word while holding the next digital word.
DAC Pinout, Features & Datasheet
DAC IC basically used in applications where an 8 bit digital data needed to be converted to analog value. Now for understanding the working let us consider the example application circuit given in the datasheet.
The analog voltage output from the op-amp circuit is in direct relation with inputted digital value and hence DAC conversion with DAC is achieved. The chip is designed with CMOS technology to achieve low power consumption and low output leakage current errors.
TL — Programmable Reference Voltage. Submitted by admin on 21 November DAC also designed with silicon-chromium R-2R resistor ladder network which divides ratasheet reference current and provides the circuit with excellent temperature tracking characteristics 0. So to convert the current parameter in to voltage parameter we will use op-amp circuit as shown dataheet circuit diagram.
The device is available in the market for low cost and can be easily worked with. This also permits the simultaneous updating of any dsc0830 of DACs.