IPMP CONFIGURATION SOLARIS 10 PDF

Oracle Solaris Administration: IP Services Oracle Solaris 10 1/13 Information An IPMP configuration typically consists of two or more physical interfaces on the . For IPMP configuration tasks, refer to Chapter 31, Administering IPMP (Tasks). Oracle Solaris IPMP involves the following software: You can configure one of the interfaces down to 10 megabits and still place the two interfaces into the. You must have configured all interfaces as members of the IPMP group. role to a user, see Chapter 2, Working With the Solaris Management Console (Tasks).

Author: Kagakasa Nikom
Country: Lithuania
Language: English (Spanish)
Genre: Love
Published (Last): 1 October 2010
Pages: 35
PDF File Size: 14.18 Mb
ePub File Size: 14.46 Mb
ISBN: 964-9-57372-905-1
Downloads: 82669
Price: Free* [*Free Regsitration Required]
Uploader: Dozahn

How to configure Solaris 10 Probe based IPMP

Puppet Automation – Live WebEx. Failure detection is the process of detecting when an interface or the path from an interface to an Internet layer device no longer works. If probe-based failure detection is used, the in. What Happens During Interface Failover The following two examples show a typical configuration and how that configuration automatically changes when an interface fails.

You must mark an IPv4 test address as deprecated to prevent applications from using the test address. Troubleshooting Network Problems Tasks An IPMP configuration typically consists of two or more physical interfaces on the same system that are attached to the same IP link. Check the IPv6 configuration.

TOP Related  BIOGRAPHY OF UTHMAN IBN AFFAN PDF

If an interface with the same name as another interface that was missing at system boot is reattached using DR, RCM automatically plumbs the interface. This process is called load spreading.

Note — You can always view the current status of an interface by typing the ifconfig interface command. After failback, the original configuration is restored. You can also see that hme1: Internet Key Exchange Reference.

Not all Sun platforms support DR. Multicast memberships also fail over from hme0 to hme1.

Introductory information about DR and the cfgadm command. In IPv6, link-local addresses are not normally placed in the name service tables.

The confighration repair detection time is twice the failure detection time, 20 seconds by default, because replies to 10 consecutive probes must be received. No test address configured on interface hme0; disabling probe-based failure detection on it. You would remove the standby status of an interface by typing the following: Probe-based failure detection involves the sending and receiving of ICMP probe messages that use test addresses.

All interfaces in an IPMP group must be of the same media configurtaion. A single interface can be configured in its own IPMP group. Failover can only occur when you have configured more than one interface in the IPMP group. Configurtion requests to detach system components that contain NICs are first checked to ensure that connectivity can be preserved.

TOP Related  FISIOLOGIA Y BIOQUIMICA VEGETAL AZCON PDF

DefaultFixed NCP to be enabled:.

How to configure Solaris 10 IPMP ? – UnixArena

The dummy address is removed when a subsequent failback takes place. RCM has no information regarding how to configure the interface. These physical interfaces might or might not be on the same NIC. IPMP does not permit you to add a data address to an interface that is configured through the solxris command as standby. Self Paced Courses Live Webex.

For example, you can use the ifconfig command to obtain the status of a standby interface. Solaris11 Self Paced Video Learning. Leave a Reply Cancel reply. You should receive a status message regarding this event. For example, to place hme0 and hme1 under group testgroup1you would type ilmp following commands:.

You should not have configured a test address on the interface to become the standby interface. These physical interfaces might or might not be on the same NIC.